Minolta Di152 Service Manual page 93

2. User's Choice Mode Setting Procedure
<Procedure>
1. Hold down the Panel Reset key for 3 seconds.
2. Enter "1" from the 10-Key Pad. (Display: U-1)
3. Press the Start key.
4. Enter the corresponding code number from the 10-Key Pad.
5. Press the Start key. Then, the Display will show the current setting value.
6. Press the Clear key to reset the current setting value.
7. Enter the new setting value from the 10-Key Pad.
8. Press the Start key. This will validate the new setting value just entered.
If any value outside the available setting range is entered, the Display shows "Err"
rejecting the entry. (The old setting value will reappear on the Display 1 sec. later.)
<Exiting the Mode>
• Press the Panel Reset key until the initial screen reappears.
3. Setting in the User's Choice Mode
Code No.
Select the priority Mixed Original Detection mode that is automatically
selected when the Power Switch is turned ON or Panel Reset key
pressed.
C-1
Select the priority paper size or paper source that is automatically
selected when the copier is set into the Auto Size or Manual mode.
C-2
Initial setting: Metric area "6"/Inch area "15"
Select the priority Auto mode (Auto Paper or Auto Size) selected
when the Power Switch is turned ON or Panel Reset key pressed.
C-3
Setting (The default is
Setting
Description Mixed Orig. enabled
Setting Description
0 A3 (L)
1 B4 (L)
2 A4 (L)
3 B5 (L)
4 A5 (L)
5 FLS (L)
A4 (C)
6
B5 (C)
7
A5 (C)
8
Ledger (L)
10
11×14 (L)
11
Setting
0
Description Auto paper
S-5
Highlighted
<Mixed Orig.>
0
Mixed Orig. disabled
<Paper Priority>
Setting
12 Legal (L)
13 Letter (L)
14 Invoice (L)
Letter (C)
15
Invoice (C)
16
1st Tray
20
2nd Tray
21
3rd Tray
22
4th Tray
23
5th Tray
24
Multiple Bypass Tray
25
<Copy Priority>
1
Auto Size
).
1
Description
2
Manual