Minolta Di152 Service Manual page 100

Code No.
Delete an account (access number) which has previously been
stored.
<Procedure>
1. Enter "3" from the 10-Key Pad. (Display: A-3)
A-3
2. Press the Start key. This will blank out the Display.
If no accounts are yet to be programmed, the contents of the Dis-
play alternate between "A-3" and "blank."
3. Press the Zoom key to display the account to be deleted.
4. Press the Start key to delete the account.
Change an access number which has previously been programmed.
<Procedure>
1. Enter "4" from the 10-Key Pad. (Display: A-4)
2. Press the Start key. This will blank out the Display.
If no accounts are yet to be programmed, the contents of the Dis-
play alternate between "A-4" and "blank."
A-4 3. Press the Zoom key to display the access number to be changed.
4. Press the Start key to validate the access number displayed.
5. Enter a new access number from the 10-Key Pad.
6. Press the Start key to validate the new access number just
entered.
If the new access number just entered already exists, "Err" appears
on the Display and then the Display blanks out.
In this case, perform steps 5 and 6 again.
Display the count of the Total Counter for each account.
<Procedure>
1. Enter "5" from the 10-Key Pad. (Display: A-5)
2. Press the Start key. This will blank out the Display.
If no accounts are yet to be programmed, the contents of the Dis-
play alternate between "A-5" and "blank."
A-5 3. Press the Zoom key to display the access number.
4. Press the Start key to validate the access number displayed.
5. Press the Start key. This will allow the Total Counter value to be
displayed.
E.g.: "123" and "456" alternate if the count is 123,456.
6. Press the Clear key to clear the count.
If the count is mistakenly cleared, press the Interrupt key, which
will restore the count just cleared.
Clear the Total Counter counts for all accounts.
<Procedure>
A-6
1. Enter "6" from the 10-Key Pad. (Display: A-6)
2. Press the Start key. Then, "CLr" appears on the Display.
3. Press the Start key again to clear all counts.
Setting (The default is
<Delete Account>
<Change Account>
<Total Counter Display by Account>
<Total Counter Clear for All Accounts>
S-12
Highlighted ).