Motorola Netopia 2200 Series User Manual page 248

set ip ip-ppp vcc1 mcast-fwd [ on | off }
Enables or disables multi-cast forwarding on the specified interface. If set to on, this inter-
face acts as an IGMP proxy host, and IGMP packets are transmitted and received on this
interface on behalf of IGMP hosts on the LAN interface. See
for more information.
set ip ip-ppp vcc1 igmp-null-source-addr [ off | on ]
Enables or disables IGMP null source address, if mcast-fwd is set to on. If enabled, the
source IP address of every IGMP packet transmitted from this interface is set to 0.0.0.0.
This complies with the requirements of TR-101, and removes the need for a publicly adver-
tised IP address on the WAN interface.
Ethernet Port Settings
set ethernet ethernet A mode { auto | 100M-full | 100M-full-fixed |
100M-half-fixed | 10M-full-fixed | 10M-half-fixed |
100M-half | 10M-full | 10M-half }
Allows mode setting for the ethernet port. Only supported on units without a LAN switch, or
dual ethernet products (338x). In the dual ethernet case, "ethernet B" would be specified
for the WAN port. The default is auto.
248
"IGMP Settings" on page 211