Motorola Netopia 2200 Series User Manual page 218

If you specify v2-MD5, you must also specify a rip-send-key. Keys are ASCII strings with a
maximum of 31 characters, and must match the other router(s) keys for proper operation
of MD5 support.
set ip dsl vccn rip-receive
{ off | v1 | v2 | v1-compat | v2-MD5 }
Specifies whether the Motorola Netopia® Gateway should use Routing Information Protocol
(RIP) broadcasts to update its routing tables with information received from other routers.
If you specify v2-MD5, you must also specify a rip-receive-key. Keys are ASCII strings
with a maximum of 31 characters, and must match the other router(s) keys for proper oper-
ation of MD5 support.
Ethernet LAN Settings
set ip ethernet A option { on | off }
Enables or disables communications through the designated Ethernet port in the Gateway.
You must enable TCP/IP functions for an Ethernet port before you can configure its network
settings.
set ip ethernet A address ip_address
Assigns an IP address to the Motorola Netopia® Gateway on the local area network. The IP
address you assign to the local Ethernet interface must be unique on your network. By
default, the Motorola Netopia® Gateway uses 192.168.0.1 as its LAN IP address.
set ip ethernet A broadcast broadcast_address
Specifies the broadcast address for the local Ethernet interface. IP hosts use the broad-
cast address to send messages to every host on your network simultaneously.
The broadcast address for most networks is the network number followed by 255. For
example, the broadcast address for the 192.168.1.0 network would be 192.168.1.255.
218