Selecting The Output Location - Xerox Phaser 3210 User Manual

Selecting the Output Location

The printer has two output locations: the face-up output slot and the face-down output
tray. You can select the output location by changing the position of the output lever on the
front of the printer. To use the face-down output tray, be sure the output lever is in upper
(normal) position. To use the face-up output slot, push it down to open the slot.
• If paper coming out of the face-down output tray has problems, such as excessive curl, try
printing to the face-up output slot.
• To avoid paper jams, do not change the position of the output lever while the printer is
printing.
Printing to the Face-Down Output Tray
The face-down output tray collects paper
face-down, in correct order. Make
sure that the output lever is in the upper
position. (If not, push it up)
The face-down output tray should be
used for most print jobs and is
recommended for printing over 100
sheets of paper, continuously.
Printing to the Face-Up Output Slot
The printer prints to the face-up output
slot if it is open. Push the output lever
down to open the slot. Paper comes out
of the printer face-up.
Using the face-up output slot might
improve output quality with the following:
• envelopes
• labels
• paper heavier than 24 lb (90 g/m
4.4
P M
RINT EDIA
2 )