HP ENVY 14 Service Manual page 81

4. Remove the battery cover and battery (see
5. Remove the hard drive (see
6.
Remove the memory module/wireless module compartment cover (see
on page
7. Disconnect the battery charger board ribbon cable from the system board (see
board on page
8. Remove the top cover (see
9. Disconnect the optical drive cable from the system board (see
10. Remove the system board (see
11. Remove the fan/heat sink assembly (see
Remove the processor:
1. Turn the processor locking screw (1) one-half turn counterclockwise, until you hear a click.
2. Lift the processor (2) straight up, and remove it.
NOTE:
embossed on the processor socket when you install the processor.
Reverse this procedure to install the processor.
ENWW
Mass storage device on page
45).
52).
Top cover on page
System board on page
The gold triangle (3) on the processor must be aligned with the triangle icon (4)
Battery on page 37).
40).
54).
Optical drive on page
66).
Fan/heat sink assembly on page
Component replacement procedures
WLAN module
Battery connector
63).
70).
73