Pressed - Denon DN-2600F Operating Instructions Manual

(2) Digital scratch
Using the scratch function
Set the ASP to the scratch mode.
1
• Refer to "Selecting the ASP mode" on page 17.
Check that it is possible to start scratching.
Press the PLAY/PAUSE button.
PLAY / PAUSE
2
• If the " " indicator is lit, scratching is possible.
GO!
Set the jog dial to the scratch mode.
Press the EFFECT button so that the DIGI-S LED flashes or
3
lights.
The DIGI-S LED lights when scratching is performed
once.
Change the playing speed and direction of playback.
Turn the jog dial.
The disc is played in the forward direction
SEARCH
SCAN
when the jog dial is turned clockwise, in
6 7
the reverse direction when the jog dial is
turned counterclockwise.
The playing speed changes according to
4
the speed at which the dial is turned.
• Press the PLAY/PAUSE button during the scratch mode to
pause in the PLAT-S mode.
• If the scratch operation is performed during normal
playback, normal playback resumes once scratching is
stopped.
• If the scratch operation is performed in the pause mode,
the pause mode is set once scratching is stopped.
(3) Effector
GO!
Lit
1-
1-
2-
Setting the effector mode
Set the ASP to the effector mode.
• Refer to "Selecting the ASP mode" on page 17.
1
In the effector mode, the playing level is 6dB lower than
the normal playing level.
After setting the effector mode, set the track's BPM.
Press the TAP (TAP/BPM) button several times in beat with
the music.
TAP
STOP
2
• The track's BPM is set according to the tempo at which
the button is pressed.
• This tempo is set as the reverb and flanger operating
time.
When the BPM is input after starting playback from the
standby position or after hot starting, the BPM can be set
individually for the different modes.
Using the filter function
With this function, the sound is filtered to reduce the low or high
range frequencies.
0Hz
Low range frequencies
After setting the effector mode, set the filter low
frequency input mode.
Press the FIL/REVERSE button.
1
L--H Freq.L
Low range frequencies
Select the low frequency range to be filtered.
Turn the data master knob (
PUSH ENTER
The frequency increases when the knob is
turned clockwise and decreases when the
knob is turned counterclockwise.
2
• The frequency can be set between 100 Hz and 20 kHz (or
none).
It is not possible to set the low frequency to a frequency
higher than the high frequency.
Set the filter high frequency input mode.
Press the data master knob (
1
Freq.H L--H
High range frequencies
ENGLISH
115bpm
20kHz
High range frequencies
EFFECT
Flashing
— ).
8 9
— ).
8 9
19