Pressed - Denon DN-2600F Operating Instructions Manual

ENGLISH
#2
EXIT/RELOOP button
• When this button is pressed during loop playback, loop
playback stops and the normal play mode is set (EXIT). When
pressed again, loop playback resumes.
#3
B (B-LOOP) button
• Press this button to set the end point for loop playback (point
B).
#4
A button (1, 2)
• Press this button to set the start point for loop playback
(point A-1 or A-2).
• Press this button to use the stutter and hot start functions.
The hot start mode is set when the loop mode is on, the
stutter mode is set when the loop mode is off.
#5
Display
• See page 10.
#6
LOOP (FLIP) button
• Press this button to switch between the loop mode/hot start
mode and stutter mode.
• The " " indicator lights when in the loop mode/hot start
LOOP
mode.
• When in the next track mode, program mode or random
mode, press this button to turn the repeat mode on and off.
#7
End monitor / Next track start button
(END MON. / START)
• Press this button in the standby mode to monitor the end of
the track.
• When this button is pressed during playback in the next track
mode, the selected track is search for. When pressed again
after the search operation, playback starts.
(5) Display
q
q
PLAT-S indicator
• This lights when in the PLAT-S mode.
w
Brake indicator
• This lights when in the brake mode.
e
Memo indicator
• This lights when memo data is stored in the memory.
r
Play mode indicators
• "SINGLE" lights when in the single track play mode.
• "CONT." lights when in the continuous play mode.
10
w e r t y u i
CONT. SINGLE REPEAT
MEMO PROG. GO!
BRAKE PLAT-S PLAT-H
¡¡¡¡¡¡¡¡¡¡¡
A1 B
LOOP EXIT
A2 B
D.OUT FULL LOCK
!2 !3 !4 !5 !6
#8
TIME button
• Press this to switch the time display between the elapsed
time or remaining time per track or per disc.
#9
Disc holder OPEN/CLOSE button
• Press this button to open and close the disc holder.
• The disc holder will not open during playback. Stop playback
before pressing this button.
$0
Continue/Single button
(CONT./SINGLE)
• Press this button to switch between the single and
continuous play modes.
• The selected mode is indicated by the SINGLE or CONTINUE
indicators on the display.
$1
Next track button (NEXT TR.)
• Press this button to set the next track mode.
• When the next track mode is set, the "NEXT TR" indicator
lights and the next track to be played can be selected using
the track select knob.
(4) RC-46 Rear Panel
$2
Connector for signal transfer between remote
control units
• When this connector is connected to the connector of
another RC-46 using a stereo mini-plug cord (cross cable),
signals can be transferred between two units.
$3
Control connector
• Connect this connector to the REMOTE connector on the
DN-2600F (main unit) using the included control cord.
o !0
TOTAL REMAIN ELAPSED NEXT TR
m s f
EOM
!7 !8 !9 @0 @1 @2
t
Program indicator
• This lights when program data has been input and when
program data is stored in the memory.
y
Repeat indicator
• This lights when the repeat mode is set.
u
Digital scratch enabled indicator
• This lights when it is possible to start digital scratching.
i
Track, minute, second and frame displays
• These displays indicate information on the current position
and time.
!1
PITCH %
LOOP
SAMP
RVS
DIGI-S
EFFECT