Using Wall Color; Adjusting Brightness; Adjusting Color - BenQ MX766 User Manual

Setting the User 1/User 2 mode
There are two user-definable modes if the current available picture modes are not suitable
for your need. You can use one of the picture modes (except the User 1/User 2) as a
starting point and customize the settings.
1. Press MENU/EXIT to open the On-Screen Display (OSD) menu.
2. Go to the PICTURE > Picture Mode menu.
3. Press
4. Press
This function is only available when User 1 or User 2 mode is selected up in the Picture Mode
sub-menu item.
5. Press
6. Press
See "Fine-tuning the image quality in user modes"
7. When all settings have been done, highlight Save Settings and press MODE/
ENTER to store the settings.
8. The confirmation message 'Setting Saved' displays.

Using Wall Color

In the situation where you are projecting onto a colored surface such as a painted wall
which may not be white, the Wall Color feature can help correct the projected picture's
color to prevent possible color difference between the source and projected pictures.
To use this function, go to the DISPLAY > Wall Color menu and press
a color which is the closest to the color of the projection surface. There are several
precalibrated colors to choose from: Light Yellow, Pink, Light Green, Blue, and Blackboard.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions available
when User 1 or User 2 mode is selected. Based on your needs, you can make adjusents
tothese functions by highlighting them and pressing
control

Adjusting Brightness

The higher the value, the brighter the image. And the
lower the setting, the darker the image. Adjust this
control so the black areas of the image appear just as
black and that detail in the dark areas is visible.
Adjusting Contrast
The higher the value, the greater the contrast. Use this
to set the peak white level after you have previously
adjusted the Brightness setting to suit your selected
input and viewing environment.

Adjusting Color

Lower setting produces less saturated colors. If the setting is too high, colors on the image
will be overpowering, which makes the image unrealistic.
40
Operation
/ to select User 1 to User 2.
to highlight Reference Mode.
/ to select a picture mode that is closest to your need.
to select a sub-menu item to be changed and adjust the value with
http://www.pureglare.com.au
below for details.
/
/ on the projector or remote
+50
+30
0
-30
/ .
to select
+70
+30