BenQ MX766 User Manual page 77

FUNCTION DESCRIPTION
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See
Picture Mode
picture mode" on page 39
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See
Reference Mode
for details.
Adjusts the brightness of the image. See
page 40
Brightness
Adjusts the degree of difference between dark and light in the image.
See"Adjusting Contrast" on page 40
Contrast
Adjusts the color saturation level -- the amount of each color in a
video image. See
Color
Adjusts the red and green color tones of the image. See
Tint" on page 41
Tint
Adjusts the image to make it look sharper or softer. See
Sharpness" on page 41
Sharpness
for details.
"Setting the User 1/User 2 mode" on page 40
This function is only available when User 1 or User 2 is selected.
for details.
This function is only available when User 1 or User 2 is selected.
This function is only available when User 1 or User 2 is selected.
"Adjusting Color" on page 40
This function is only available when User 1 or User 2 is selected.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC or PAL.
for details.
This function is only available when User 1 or User 2 is selected.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC or PAL.
for details.
This function is only available when User 1 or User 2 is selected.
http://www.pureglare.com.au
"Selecting a
"Adjusting Brightness" on
for details.
for details.
"Adjusting
"Adjusting
Operation
77