Entering The Password Recall Procedure; Changing The Password - BenQ MX766 User Manual

record the password in this manual, and you absolutely do not remember it, you can use
the password recall procedure. See
for details.
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.

Entering the password recall procedure

1. Press and hold AUTO on the projector or
remote control for 3 seconds. The projector
will display a coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local BenQ service center to
decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the
projector.

Changing the password

1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security
Settings > Change password menu.
2. Press MODE/ENTER. The message 'INPUT CURRENT PASSWORD' displays.
3. Enter the old password.
• If the password is correct, another message 'INPUT NEW PASSWORD'
displays.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT CURRENT PASSWORD' displays for
your retry. You can press MENU/EXIT to cancel the change or try another
password.
4. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it is
available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password
to the projector. Remember to enter the new
password next time the projector is started.
7. To leave the OSD menu, press MENU/EXIT.
"Entering the password recall procedure" on page 35
http://www.pureglare.com.au
35
Operation