Table of Contents
Advertisement
There are two user-definable modes if the current available picture modes are not
suitable for your need. You can use one of the picture modes (except the User 1/
User 2) as a starting point and customize the settings.
1.
Press Menu/Exit to open the On-Screen Display (OSD) menu.
2.
Go to the PICTURE > Picture Mode menu.
3.
Press
/
4.
Press
to select Reference Mode.
This function is only available when User 1 or User 2 mode is selected up in
the Picture Mode sub-menu item.
5.
Press
/
6.
Press
to select a sub-menu item to be changed and adjust the value with
. See
"Fine-tuning the image quality in user modes"
7.
The settings will be saved when selecting.
Using Wall Color
In the situation where you are projecting onto a colored surface such as a painted wall
which may not be white, the Wall Color feature can help correct the projected
picture's color to prevent possible color difference between the source and projected
pictures.
To use this function, go to the DISPLAY > Wall Color menu and press
select a color which is the closest to the color of the projection surface. There are
several precalibrated colors to choose from: Light Yellow, Pink, Light Green, Blue, and
Blackboard.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions
available when User 1 or User 2 mode is selected. Based on your needs, you can
make adjustments to these functions by selecting them and pressing
projector or remote control.
Adjusting Brightness
The higher the value, the brighter the image. And
the lower the setting, the darker the image. Adjust
this control so the black areas of the image appear
just as black and that detail in the dark areas is
visible.
Adjusting Contrast
The higher the value, the greater the contrast. Use
this to set the peak white level after you have
previously adjusted the Brightness setting to suit
your selected input and viewing environment.
You can also adjust Brightness or Contrast by using
BRIGHT or CONTRAST key on the remote control.
Adjusting Color
Lower setting produces less saturated colors. If the setting is
too high, colors on the image will be overpowering, which makes the image
unrealistic.
to select User 1 to User 2.
to select a picture mode that is closest to your need.
below for details.
/
/
on the
+50
+50
+30
+30
0
-30
Operation
/
to
+70
+70
+30
39
Advertisement
Table of Contents
