Completing The Assembly; Removing The Protective Film - Precor TRM 211 Quick Start Card

Treadmill 211 Assembly Guide

Completing the Assembly

The bottle holders attach to brackets on either side of the display console.
To attach the right and left bottle holders:
1. Slide the two bottle holders onto their brackets and secure each using an
M5 x 10 mm buttonhead screw and 5.2 mm washer. Fully tighten each screw.
Figure 13: Bottle attachments
2. Place the magnetic stop key into the cutout on the display.
Figure 14: Stop key attachment

Removing the Protective Film

The treadmill ships with a protective film over the Precor logos and on the
face of the console. To remove the film, grasp the edge of it and peel it off
the equipment.
10