Spa Fill Up Procedure - Jacuzzi J - 2 0 Owner's Manual

8.0

spa Fill up procedure

For best results, read each step in its entirety before proceeding with that
step.
1. prepare The spa For Filling
• Clear all debris from the spa. (Although the spa shell has been
polished at the factory, you may want to treat it with a specially
formulated spa cleaner.) Consult your authorized Jacuzzi dealer for
additional information prior to filling spa.
• Remove filter cover, then remove filter cartridge as outlined in section
12.1 (page 32).
2. Fill spa
• Place the end of your garden hose into the empty filter bucket.
CauTIon: To DeCrease BuIlD up on ComponenTs anD
mInImIZe aCrYlIC DamaGe.
Never fill with water from a water softener. If your water is extremely
"hard", it is preferable to fill half-way with hard water and the rest of
the way with softened water. You may fill entirely with hard water if
you use a special water additive available from your Jacuzzi dealer.
!
warnInG:
•
DIsease.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments. Fill until water covers all jets but does not
touch the bottom of the lowest headrest. (DO NOT OVERFILL!)
3. Turn on power
Turn on power to spa at the home's circuit breaker to start boot
up sequence (sec. 10.0, page 25). The heater and filter pump will
automatically activate after several seconds. If the control panel LED
flashes water temperature and "COL" or "ICE" this is normal, refer to
page 39 for additional information.
4. activate Jets pumps
Turn on jets pump(s) to ensure proper mixing when
adding start-up chemicals in step 5.
5. add start-up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See section 13.0 "Water Quality Maintenance" (page 37)
for general guidance.
To DeCrease rIsk oF InFeCTIon or
J-200 Series
1
2
19