Fingerprint Reader Board (Select Models Only) - HP ENVY 15 Maintenance And Service Manual

Fingerprint reader board (select models only)

Description
Fingerprint reader board for use only on select HP ENVY 15 Computer Notebooks models
Fingerprint reader board for use only on select HP ENVY 17 Computer Notebooks models
Before removing the Fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the subwoofer (see
9. Remove the system board (see
Remove the fingerprint reader board and cable:
1. Disconnect the ZIF connector cable (1) that secures the fingerprint reader to the top cover.
2. Release the top cover shield (2) and (3), and then remove the fingerprint reader board (4) by
lifting the board.
Reverse this procedure to install the fingerprint reader board and cable.
Battery on page 42),
Optical drive on page
WLAN module on page
Subwoofer on page
System board on page
43).
Base enclosure on page
59).
63).
67).
Component replacement procedures
Spare part number
763789-001
763711-001
46).
75