11.
On select models, removing the cable also requires disengaging it from the channels in the
hinges and disconnecting from the display panel. To disconnect the cable from the display
panel, carefully remove the foil tape at the bottom of the display panel and then carefully lift the
display cable connector (1) and remove the display connector (2).
12.
If it is necessary to replace the webcamera/microphone perform the following: Lift the module (1)
from the adhesive holding it in place on the display bezel and disconnect the module connector
(2) if you have not already done so when removing the display cable.
13.
If it is necessary to replace the WLAN antenna cable, follow these procedures:
a.
Position the display back cover face up.
Component replacement procedures
57