Table of Contents
Advertisement
WARNING
PRECAUTIONS
Product Cleaning
Use a soft dry cloth for periodic cleaning of
the product. For more severe stains, please
dampen the cloth with water only. Anything
else has the chance of dissolving the paint or
damaging the plastic.
Temperature
Be sure the temperature inside the vehicle is
between +60°C (+140°F) and –10°C (+14°F)
before turning your unit on.
Moisture Condensation
You may notice the disc playback sound
wavering due to condensation. If this
happens, remove the disc from the player and
wait about an hour for the moisture to
evaporate.
Damaged Disc
Do not attempt to play cracked, warped, or
damaged discs. Playing a bad disc could
severely damage the playback mechanism.
Maintenance
If you have problems, do not attempt to
repair the unit yourself. Return it to your
Alpine dealer or the nearest Alpine Service
Station for servicing.
Never Attempt the Following
Do not grip or pull out the disc while it is
being pulled back into the player by the
automatic reloading mechanism.
Do not attempt to insert a disc into the unit
when the unit power is off.
4
-
EN
Autogood products internet store http://130.com.ua
Inserting Discs
Your player accepts only one disc at a time
for playback. Do not attempt to load more
than one disc.
Make sure the label side is facing up when
you insert the disc. Your player will
automatically eject any disc that is inserted
incorrectly. If the player continues to eject a
correctly inserted disc, push the RESET
switch with a pointed object such as a
ballpoint pen.
Playing a disc while driving on a very bumpy
road may result in skips, but this will not
scratch the disc or damage the player.
New Discs
As a protective measure to prevent the Disc
from jamming, the DVD player will
automatically eject discs with irregular
surfaces or inserted incorrectly. When a new
disc is inserted into the player and ejected
after initial loading, using your finger, feel
around the inside of the centre hole and
outside edge of the disc. If you feel any small
bumps or irregularities, this could inhibit
proper loading of the disc. To remove the
bumps, rub the inside edge of the hole and
outside edge of the disc with a ballpoint pen
or other such instrument, then insert the disc
again.
Bumps
Centre Hole
Centre Hole
New Disc
Outside
(Bumps)
Advertisement
Table of Contents
