Table of Contents
Advertisement
Disc playback sound skips due
to vibration.
• Improper mounting of the unit.
- Securely re-mount the unit.
• Disc is very dirty.
- Clean the disc.
• Disc has scratches.
- Change the disc.
• The pick-up lens is dirty.
- Do not use a commercial available
lens cleaner disc. Consult your nearest
ALPINE dealer.
Disc playback sound skips
without vibration.
• Dirty or scratched disc.
- Clean the disc; damaged disc should
be replaced.
CD-R/CD-RW playback not
possible.
• Close session (finalization) has not
been performed.
- Perform finalization and attempt
playback again.
Error displays
• Mechanical error
- Press . After the error indication
disappears, insert the disc again. If the
above-mentioned solution does not
solve the problem, consult your
nearest ALPINE dealer.
MP3 or WMA is not played back.
• Writing error occurred. The CD format
is not compatible.
- Make sure the CD has been written in
a supported format. Refer to "About
MP3/WMA" on pages 122-123, then
rewrite in the format supported by this
device.
Unit does not operate.
• Monitor's power is not turned on.
- Turn on the monitor's power.
• Condensation.
- Wait a while (about 1 hour) for the
condensation to dry.
Autogood products internet store http://130.com.ua
No picture is produced.
• Monitor's mode is not switched to the
mode you want to see.
- Switch to the mode you want to see.
• Monitor's parking brake cord is not
connected.
- Connect the monitor's parking brake
cord and set the parking brake.
(For details, refer to the monitor's
instructions.)
• Monitor's parking brake is not set.
- Connect the monitor's parking brake
cord and set the parking brake.
(For details, refer to the monitor's
instructions.)
Playback does not start.
• Disc is loaded upside-down.
- Check the disc and load it with the
labeled side facing upward.
• Disc is dirty.
- Clean the disc.
• A disc not able to playback with this
unit is loaded.
- Check if the disc is able to be played
back.
• Parental lock is set.
- Cancel the parental lock or change the
rating level.
Picture is unclear or noisy.
• Disc is being fast-forwarded or fast-
reversed.
- The picture may be slightly disturbed,
but this is normal.
• Vehicle's battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the
battery power is under 11 volts with a
load applied.)
• Monitor's fluorescent tube is worn.
- Replace the monitor's fluorescent
tube.
Image stops sometimes.
• Disc is scratched.
- Replaced with a non-scratched disc.
125
-
EN
Advertisement
Table of Contents
