Using The Clock - Rangemaster Nexus 110 Dual Fuel User's Manual & Installation Instructions

Fig. 2.29
ArtNo.306-0001 - 3-button clock
Fig. 2.30
ArtNo.306-0001 - 3-button clock
Fig. 2.31
ArtNo.306-0001 - 3-button clock
mode [M] whilst
By pressing the
down, it is possible to see time remaining or adjust the
countdown time using the [+] or [-] buttons.
Fig. 2.32
ArtNo.306-0001 - 3-button clock
Fig. 2.33
ArtNo.306-0001 - 3-button clock
Fig. 2.34
ArtNo.306-0001 - 3-button clock
TOP TIP
Minute Minder
is counting
Operating the Ovens
Operating the Multifunction Oven
The multifunction oven has two controls: a function selector
and a temperature setting knob (Fig. 2.26).
Turn the function selector control to a cooking function. Turn
the oven temperature knob to the temperature required (Fig.
2.27).
The oven heating light will glow until the oven has reached
the temperature you selected (Fig. 2.28). It will then cycle on
and off during cooking as the oven maintains the selected
temperature.
Operating the Fan Oven
Turn the oven knob to the desired temperature (Fig. 2.27).
The oven indicator light will glow until the oven has reached
the temperature selected (Fig. 2.28). It will then cycle on and
off during cooking.

Using the Clock

You can use the clock to turn the left-hand oven on and off.
Note: When using the timer functions, first set the clock as
required before setting the oven temperature.
The oven can be switched on when the cook symbol [ ] is
displayed.
Setting the Clock
1.
The LCD clock is shown in (Fig. 2.29). Once the cooker
is connected and switched on, the display flashes (
00 . 00 ) and the time starts from (00 . 00 ).
2.
To set the clock press the [+] and [-] buttons
simultaneously, the point between hours and minutes
will start to flash for 5 seconds. Whilst the point is
flashing press either the [+] or [-] button to set the
correct time.
IMPORTANT: The timed oven will not operate unless the
clock has been set.
Program Selection - Setting the Minute Minder
The minute minder [ ] provides the ability to set a
countdown from 00 . 01h to 23 . 59h, at the end of which an
alarm will sound.
1.
Press the mode [M] button once (Fig. 2.30). The bell
symbol ( ) will flash on the display. Select the desired
countdown from 00 . 01h to 23 . 59h using the [+] button
(Fig. 2.31). The countdown will automatically begin
and the ( ) symbol will show in the display.
2.
Once the specified time has elapsed an alarm will
sound.
3.
To stop the alarm press any button.
12