1. Manuals
  2. Brands
  3. Directed Electronics Manuals
  4. Remote Starter
  5. Viper 5501
  6. Owner's manual

Directed Electronics Viper 5501 Owner's Manual

Remote start keyless entry
Hide thumbs Also See for Viper 5501:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Installation Manual
Enlarged version
Responder LC Model 5501
Remote Start Keyless Entry
Owner's Guide
© 2008 Directed Electronics, Vista, CA
G4702V 2008-08

Advertisement

Table of Contents
loading

Related Manuals for Directed Electronics Viper 5501

Summary of Contents for Directed Electronics Viper 5501

  • Page 1 Responder LC Model 5501 Remote Start Keyless Entry Owner’s Guide © 2008 Directed Electronics, Vista, CA G4702V 2008-08...

  • Page 3: Table Of Contents

    Contents Government regulations ..................4 Warning! Safety first ..................5 What’s included ....................8 Important information ..................8 Your warranty...................8 Replacement remote ..................8 Out of range notification................9 Charging the Battery .................9 Low battery indicator ................10 Battery Replacement ................10 Multi-car control capability ..............11 Responder LC 2-way ..................12 LC 1-way companion ................13 Transmitter configuration ................13 Using the system .....................14...

  • Page 4: Government Regulations

    The device and its antenna must maintain a separation distance of 20 cm or more from the person’s body, is designed to be used in a person’s hands and its operating configurations do a person’s body. © 2008 Directed Electronics. All rights reserved.
  • Page 5 IC. In addition, the user of this device must accept any radio interference that may be received, even if this interference could affect the operation of the device. Warning: compliance could void the user’s authority to operate this device. © 2008 Directed Electronics. All rights reserved.

  • Page 6: Warning! Safety First

    Before remote starting a manual transmission vehicle, be sure to: Leave the vehicle in neutral and be sure no one is standing in front or behind the vehicle. Only remote start on a flat surface Have the parking brake fully engaged WARNING! © 2008 Directed Electronics. All rights reserved.
  • Page 7 THORIZED Directed DEALER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START MODULE. DIRECTED WILL NOT BE HELD RESPONSIBLE OR PAY FOR INSTALLATION OR REINSTALLATION COSTS. This product is designed for fuel injected vehicles only. Use of this product in a © 2008 Directed Electronics. All rights reserved.
  • Page 8 This product should not be installed in any convertible vehicles, soft or hard top with a manual transmission. Installation in such vehicles may pose certain risk. © 2008 Directed Electronics. All rights reserved.

  • Page 9: What's Included

    It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. Replacement remote controls please see your authorized dealer or visit www.directedstore.com to order. © 2008 Directed Electronics. All rights reserved.

  • Page 10: Out Of Range Notification

    LCD. Once the battery has accumulated enough charge for functionality, the LCD icons initialize with a beep sound, the battery status outline stops flashing and the remote becomes operational while still displaying © 2008 Directed Electronics. All rights reserved.

  • Page 11: Low Battery Indicator

    Ask your authorized dealer if you have any questions. Battery Replacement battery. Place the new battery into the remote control. When power is returned the remote control is ready for use. © 2008 Directed Electronics. All rights reserved.

  • Page 12: Multi-Car Control Capability

    To scroll from one to the other press the button again. When using the remote to control the system, the amber light will flash in a sequence of 1 or 2 flashes indicating the current vehicle mode. © 2008 Directed Electronics. All rights reserved.

  • Page 13: Responder Lc 2-Way

    Back of remote has label to identify the remote as 2-way or 1-way. Battery Door (1-way) For accessing batteries when necessary. Transmit LED (1-way) Active when communicating Note: If Keypad Lock is On, press and then press to exit. © 2008 Directed Electronics. All rights reserved.

  • Page 14: Lc 1-Way Companion

    Car Finder Remote Start Reset Timer Mode Smart Start Rear Runtime Defogger Trunk Release AUX 1 AUX 2 AUX 3 A U X Function Shift Cabin Runtime Temperature Check request (2-way only) (2-way only) © 2008 Directed Electronics. All rights reserved.

  • Page 15: Using The System

    The system locks without the confirmation honk. The parking lights flash once. The 2-way re- mote displays the icon. If no lock confirmation is received, the 2-way remote emits the Out Of Range signal. © 2008 Directed Electronics. All rights reserved.
  • Page 16 The system has a feature, if programmed on, that automatically notifies you when the runtime is running low. When the system reaches 3-minutes and 1-min- ute of runtime remaining, it sends the 2-way remote control a paging signal. © 2008 Directed Electronics. All rights reserved.
  • Page 17 flash after a couple of seconds turn off the ignition and the the car will remain running. If the vehicle shuts down, then the unit did not enter valet take-over mode. © 2008 Directed Electronics. All rights reserved.
  • Page 18 Bitwriter programming tool. Function shift Command : Press 1 to 4 times. (See Transmitter configuration table) Feedback mand received. Notes Each Press then release, shifts the function of the command but- ton. © 2008 Directed Electronics. All rights reserved.
  • Page 19 Command: Press two-times and then Feedback: Notes: If the system is already locked the remote beeps unlock icon is displayed but the doors stay locked. Turn the ignition key on and then off. Note: © 2008 Directed Electronics. All rights reserved.
  • Page 20 The 2-way remote blinks the LOCK icon to confirm locking. If no lock confirma- tion is received, the 2-way remote gives the Out Of Range signal. Fail-Safe Starter Kill The starter is disabled by the system’s Fail-Safe starter kill. Silent unlock © 2008 Directed Electronics. All rights reserved.
  • Page 21 If the Override Switch has been pro- grammed to a new number of presses by your authorized dealer, that number should be indicated below. Override Switch Number ___________ © 2008 Directed Electronics. All rights reserved.

  • Page 22: Additional Remote Start Features

    The parking lights lock the system and the car will remain running. If the vehicle shuts down when locking, then the unit did not enter valet take-over mode. © 2008 Directed Electronics. All rights reserved.
  • Page 23 . Parking lights flash slowly four times To exit timer mode without transmitter: Make sure the remote start system is not operating the engine. slowly four times. Note: and, it can change the intervals between activations in timer mode. © 2008 Directed Electronics. All rights reserved.
  • Page 24 (the one way remote only flashes the parking lights). Turn off the ignition (car stays running). At this point the vehicle stays running for the programmed runtime. © 2008 Directed Electronics. All rights reserved.
  • Page 25 (factory setting is for 1 pulse). The remote emits the remote The car remains running for the pre-programmed amount of time. © 2008 Directed Electronics. All rights reserved.
  • Page 26 55 degrees or below when this feature is wired and enabled. Smart start Command : Press three-times and then press Feedback The parking lights flash 5 times fast and 'Smart Start On" dis- © 2008 Directed Electronics. All rights reserved.
  • Page 27 The Smart Start function works similar to the Timer mode.The system must be in the thresholds have been met. If thresholds have been met then the remote start will start the vehicle and run for © 2008 Directed Electronics. All rights reserved.
  • Page 28 5 start cycles. If the threshold has not been met then the system will not start the vehicle, and 6 start cycles are left. The unit continues to check threshold levels every 3 hours. © 2008 Directed Electronics. All rights reserved.

  • Page 29: Auxiliary Features

    Feedback Notes details. Aux 2 Command : Press two times and then press Feedback Notes tails. Aux 3 Command : Press three times and then press Feedback Notes tails. © 2008 Directed Electronics. All rights reserved.

  • Page 30: Remote Control Feature Programming

    1 second to save the feature. The LCD screen returns anytime by pressing the . Programming mode is automatically Note: © 2008 Directed Electronics. All rights reserved.

  • Page 31: Remote Setup Options

    Back alert Car 2 Home Back Back light color Back Temp units F° C° Back Button press back beep System type Remote start Remote start Back & Security Clock set Clock time Back © 2008 Directed Electronics. All rights reserved.

  • Page 32: Menu Option Descriptions

    Remote start display: Clock, temperature and runtime sequence. Clock displays the current time during remote start. Temperature displays the current cabin temperature during the remote start. Runtime displays the runtime remaining during the remote start. © 2008 Directed Electronics. All rights reserved.
  • Page 33 Once the desired time has been reached you can either choose "back" in the menu or press © 2008 Directed Electronics. All rights reserved.

  • Page 34: Pair Remote Setup

    The LCD icons display one at a time until they are all turned on. The remote does not play any tones. Note: If the charger is plugged into the remote and demo mode is acti- vated, the remote plays the demo mode continuously. The continuous loop © 2008 Directed Electronics. All rights reserved.

  • Page 35: Safety Features

    To disable the remote start, move the shutdown toggle switch to the Off position. Check with your installer for the location of the shutdown switch. Location of Shutdown Switch____________________________ © 2008 Directed Electronics. All rights reserved.

  • Page 36: Diagnostics

    Note: Bypass Notification does not occur when the system is in Silent Mode or if the notification honks have been programmed Off by the installer. Unlocking remote are low and need to be replaced. Important: The optional horn honk feature must be installed. © 2008 Directed Electronics. All rights reserved.

  • Page 37: Remote Start

    flash between 5 - 8 times to indicate what caused the no start situa- tion. defeat toggle switch is off. Keep a record of the number of flashes, to assist your installer when taking the vehicle in for service. © 2008 Directed Electronics. All rights reserved.

  • Page 38: Owner Recognition

    24 hours the LED will flash at half its normal rate, decreasing the system’s cur- rent draw. Power Saver in Valet Mode: on the Responder LC control center illuminates steadily. If the vehicle is not used © 2008 Directed Electronics. All rights reserved.

  • Page 39: 2-Way Remote

    If your installer is programming the system, ignition lock and unlock are independent features that can be programmed separately. Panic mode enabled pletely turned Off. (Some states have laws against horns continually honk- ing in moving cars.) © 2008 Directed Electronics. All rights reserved.

  • Page 40: Convenience Expansions

    Power Window Control: Automatic power window control is provided with the 529T and 530T systems. These can operate power windows, and can roll them up automatically when the system is Locked, roll them down, or both up and down. © 2008 Directed Electronics. All rights reserved.

  • Page 41: Glossary Of Terms

    Valet Button: A small push button switch located on your systems control center. It is used to override the starter interrupt when a 2-way remote is lost or damaged, © 2008 Directed Electronics. All rights reserved.
  • Page 42 LCD Iayout LCD remote features Lock Locked in valet Battery Status Unlock Unlocked in valet Alarm Remote Start Timer Mode Pager On Manual Transmission En- Pager Off abled © 2008 Directed Electronics. All rights reserved.
  • Page 43 Car Door Pager Tone On Car 1 Transmit Car 2 Receive Out of Range Defroster Sound Wave Car Door (Zone bypass) to 4702 model. © 2008 Directed Electronics. All rights reserved.

  • Page 44: Quick Reference Guide

    . The unlock icon turns on and the LCD displays "silent unlock". Remote Start Press display "remote start on" when activating. When deactivating the remote display "remote start Off". © 2008 Directed Electronics. All rights reserved.
  • Page 45 Before turning Off the engine, press and release the button. Then wait a few seconds. Turn the ignition key to the Off position. The engine will remain running until the programmed time elapses or a shut-down input is received. © 2008 Directed Electronics. All rights reserved.

  • Page 46: Limited Lifetime Consumer Warranty

    BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE AND WARRANTY OF NON- DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON OR ENTITY TO ASSUME DIRECTED DISCLAIMS AND HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS © 2008 Directed Electronics. All rights reserved.
  • Page 47 SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE HAS NOT BEEN PURCHASED FROM DIRECTED, OR AN AUTHORIZED DIRECTED sion or limitation of incidental or consequential damages. This warranty gives you specific legal rights and you may also have other rights that vary from State to State. This warranty is only valid for sale of product(s) within the United States of America.
  • Page 48 The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology.

Table of Contents