Table of Contents
Advertisement
Notes
:
Enables or disables the SmartStart feature. The smart start fea-
ture of this system will allow you to have the remote start ac-
tivate when the vehicle reaches a certain temperature (hot or
cold) or a certain voltage. The factory setting for temperature
high is 100 °F the setting for low is 0 °F. The voltage setting is
These settings can be adjusted or turned off by your installer
when using the Bitwriter.
To activate the Smart Start Mode with a manual transmission:
1.
Enter the MTS procedure.
2.
shut down when locking).
3.
Press the
button on the remote 3 times and then press the
4.
The 2 way remote will beep once and Smart Start On is displayed in the
5.
The parking lights on the vehicle will flash 5 times fast confirming entry into
smart start mode
6.
The vehicle will now remote start when the cabin temperature reaches
the programmed thresholds or when the vehicle battery reaches the pro-
grammed voltage.
the remote or can be deactivated manually by turning on the ignition or pressing
the brake pedal in the vehicle. The parking lights will flash 5 times slow confirm-
:
Details
Smart start uses temperature and voltage settings to determine when the
vehicle should start and run. If any changes to temperature or voltage are made
using the Bitwriter programming tool Smart start activation is affected.
The Smart Start function works similar to the Timer mode.The system must be in
the thresholds have been met.
If thresholds have been met then the remote start will start the vehicle and run for
© 2008 Directed Electronics. All rights reserved.
button on the remote (the vehicle will
button.
-
27
Advertisement
Table of Contents
