Directed Electronics Viper 5501 Owner's Manual page 26

Runtime check
Command
: While the remote start is running, press
Hold for 1.5 seconds.
Feedback
Notes
: This feature is only available on the 2way remote.
Runtime reset
Command
: While the remote start is running, press
.
Feedback
: Remote start ON tones.
Notes
: Re-starts the remote start runtime counter if remote start is ac-
tive. Note: If remote start is not active, the 2-WAY remote will
respond with error tone.
Rear defogger
Command
: Press four times, and then
on.)
Feedback
:
Notes
: While the remote start is running the defroster will manually be
turned on for one remote start cycle. When the remote start
shuts down, the defroster will work normally. The defroster turns
on when the temperature inside the vehicle is 55 degrees or
below when this feature is wired and enabled.
Smart start
Command
: Press three-times and then press
Feedback
: The parking lights flash 5 times fast and 'Smart Start On" dis-
26
two-times, and then
one-time and then
. (Only after remote start is
.
© 2008 Directed Electronics. All rights reserved.