Optional Ignition Lock/Unlock Feature; Eliminating The Arm / Disarm Chirps - Audiovox AS-9234 Owner's Manual

Upgrade vehicle security & remote start system
Hide thumbs Also See for AS-9234:
Table of Contents

Advertisement

You will note the LED flashing five times, pause, and then flash two times,
pause. This pattern will be repeated three times indicating the new code (52)
has been accepted and stored in memory.
NOTE: If after step 8, the LED flashes a code other than what was just
entered, this indicates that the code has not been changed. You
will have to repeat steps 1 through 8 above being certain to note the
following:
Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a
0 (Zero), or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off
`
for more then 5 seconds during any of the above steps, the unit will
revert back to the last successfully stored code.

OPTIONAL IGNITION LOCK/UNLOCK FEATURE:

If your existing factory installed keyless entry system did not include an
ignition on/off door lock and unlock feature, this feature can be activated from
this upgrade system. When this accessory has been added, any time the
ignition key is turned to the on position and all vehicle doors are closed, the
doors will lock in 4 seconds. Additionally, any time the ignition key is turned
to the off position, the doors will unlock.

ELIMINATING THE ARM / DISARM CHIRPS:

The normal arming and disarming confirmation chirps can easily be turned off
using the PRLED, or the optional push-button switch found on the glass
mounted receiver assembly assembly. To do this;
1. Turn the ignition key on, and then off.
2. Within 10 seconds of turning the ignition key off, press and release the
PRLED, or the optional push-button switch found on the glass mounted
receiver assembly 3 times.
3. a. If, before proceeding with step 1, the chirps were on, then you will hear
2 chirps to indicate that the chirps have been turned off.
b. If, before proceeding with step 1, the chirps were off, then you will hear
1 chirp to indicate that the chirps have been turned on.
Page 11
128-8970a
11 of 20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents