Arming The System - Active - Audiovox AS-9234 Owner's Manual

NOTE: All functions of the system will be controlled by the factory transmitter,
including the start sequence. If you find the operating range to be
less than desired, Audiovox offers an optional one button transmitter
kit which can be added to increase operating range for starting and
unlocking while running under control of the the remote start.
WARNING! Be certain that the vehicle is outdoors before using this or an
remote vehicle starting device. A running engine produces
dangerous carbon monoxide fumes which can be harmful or
fatal if prolonged exposure occurs. DO NOT remote start the
vehicle if it is garaged.
NOTE: Your system has the option of using a siren, the vehicle horn, or both
for the sounding device. Where the siren is referenced below, the
horn or both may in fact chirp, or beep.

ARMING THE SYSTEM - ACTIVE

1. Turn the ignition key off, exit the vehicle and close all doors.
2. Press and release the Lock button on the keychain transmitter.
3. The siren and or horn will beep one time, the parking lamps will flash one
time, and the Dash Mounted, LED or the optional LED found on the glass
mounted windsheild receiver will begin to slowly flash, indicating that the
system is ARMED.
If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood
lid ajar. Simply close the opened entry point to provide full protection. If the
siren "chirped" three times, sometime after arming, the exclusive delayed
dome light learn circuit has been programmed and the system detected a
open entry point after the learned delay expired. Again, closing the hood,
trunk, or doors will correct the problem and you do not need to disarm the
system to make the correction. If the siren/horn did not sound when arming,
then the chirps have been turned off, and you should refer to the section
titled " ELIMINATING THE ARM / DISARM CHIRPS " in this manual.
4. Any time the door lock switch in the vehicle is used to lock the doors
while the ignition key is turned off, the system will immediately arm.
To lock the doors after entering the vehicle, make sure the ignition key is
switched on first. Turning the ignition key on first will stop the system from
arming.
Page 3
128-8970a
3 of 20