Audiovox AS-9234 Owner's Manual page 9

your system can be overridden allowing operation of the vehicle. The manual
override code is pre-programmed at the factory to 11. This code can be changed
by the operator to a more familiar two digit number. Once you've become
familiar with the system's operation and override procedure, we suggest you
change the code for added security.
NOTE: The override procedure below describes use, assuming that the
factory preset code has not been changed and is still set to the
factory default 11.The dash mount PRLED, or the optional on glass
receiver's LED valet/override push button switch is used to enter
the tenths and units digits, pressing and releasing this button
one time for each digit required.
If your system has been selected for Custom Code manual override as indi-
cated on the last page of this manual, to bypass the alarm system; with a
code of 11, follow the sequence listed below:
1. The LED is flashing indicating the unit is armed, enter the vehicle, the siren
will sound, turn the ignition switch to the "on" position.
2. Within 10 seconds begin to enter tenths digit of override code.
(In this ex-ample the code is 11, so press and release the dash mounted
PRLED, or the optional push-button switch found on the glass mounted
receiver assembly one time).
3. Within 10 seconds of entering the last tenths digit, turn ignition "off then
on".
4. Within 10 seconds of turning the ignition switch on, begin to enter units
digit of override code. (In this example the code is 11, so press and
release the dash mounted PRLED, or the optional push-button switch
found on the glass mounted receiver assembly one time).
5. Within 5 seconds after the last units digit is entered, turn the ignition
switch off, then on, and start your vehicle.
If the manual override code is entered properly, the unit stops sounding, the
LED turns off, indicating a successful override. The system is now disarmed
and you can start and operate your vehicle. The unit will allow three attempts
to disarm via the manual override sequence. If the code is not successfully
entered within the three attempts, disarming with the manual override switch
will be locked for 10 minutes.
Page 9
128-8970a
9 of 20