Table of Contents
Advertisement
AA-9005 SYSTEM OPERATION
Arming
The System
1.
Exit
the vehicle and dose all doors, trunk. hatch and hood.
2.
Depress the button on your remote keychain transmitter and
observe the following:
a.
The siren will "chirp· once to give you an audible confirmation
that the system is armed.
b.
The red
LE.D.
on the front
of
the Sensor/Control Module will
begin to flash, indicating that the system is armed.
Disarming The
System
1. Upon retuming to the vehicle
~epress
the button on your remote
keychain
transmitte~
and observe the following:
a.
The siren will "chirp" to give you an audible confirmation
that the system has been disarmed.
b. The red
LE.D.
on the front of the Sensor/Control Module will
stop bUnking, indicating the system is disarmed.
Using
The Remote PanIc
E$atu(f~
1. The panic feature will operate regardless of whether the alarm is
in the armed-mode or the disarmed mode.
2.
To activate the remote
panic
mode simply hold down the button on
your remote keychain transmitterfor approximately 3 seconds until
the siren begins to sound.
3. To deactivate the remote panic mode momentanly depress the
keychain transmitter button. The siren will stop sounding and chirp
to let you know the system is disarmed.
' "
.
"".~
' .
' "
'
.......
_----------
Attempted Break-In IndIcator
1.
!he
M-900S
wlll let you
know if
a force able entry was attemp'
•
In
your absence.
_
2.
Upon returning to your vehicle do not disarm the system beft
checking the status
LE.D.
indicator lights on the face
of
Y'
SensoriControl Module.
H
the yellow
LE.D.
is flashing
it
indica
that the alarm
was
triggered in your absence.
3.
lheflashingyellowindicatoriscancenedwhentheunitisdisarm
Remoylng ?ower And Shutting
The
System Down
To prevent tampering with the system both the Siren Module,
the Sensor/Control Module have internal back-up batteries that '
allow the system to
work
even
if
the major components are disconnec
from the vehide's main power source. To shut the system power off
servicing or to disconnect power cables, procaed as follows:
1. Disarm the system with the remote keychain transmitter.
2.
Locate one of the two small tubular security power keys (8).
3. Insert the key into the security key-switch located on the
Sen~
Control Module (1) and tum to the OFF position. See figure
<-
NOTE: If you fall to disarm the Sensor/Control Module
desalbed above, when you attemptto remove the power
p~
from either the cigarette lighter or the Siren/Control Mod;
the alarm will activate and the siren will sound! (You can
51
It with
your remote keychaJn transmitter).
4. !tis now okay to remove the SensoriControl Module's powerplu
Page 15
Advertisement
Table of Contents
