Audiovox AS-9234 Owner's Manual page 13

Upgrade vehicle security & remote start system
Hide thumbs Also See for AS-9234:
Table of Contents

Advertisement

When you arrive at your vehicle, unlock by pressing and releasing the unlock
button of your keychain transmitter or by use of the vehicle key.
Enter the vehicle and turn the ignition key to the on position.
CAUTION!
Do not turn the key to the start position. This will cause the
starter motor to engage with the already running engine which
could result in damage. Step on the brake pedal to disengage
the remote start unit. The vehicle will continue to run on its
own power.
REMOTE STARTING USING THE OPTIONAL
RECEIVER/TRANSMITTER KIT:
Press and release the start button of your Remote Start transmitter two times
in succession to activate the remote start system. The vehicle will start and
remain running for the pre-programmed time of up to 60 minutes. As a visual
indication, the parking lights will flash or turn on as pre-selected by your
installation center at time of installation. You may also start the vehicle with
the factory transmitter by pressing lock, unlock, lock in succession.
When you arrive at your car, unlock the vehicle by pressing and releasing the
unlock button of your factory keychain transmitter, or pressing and holding for
3 seconds the start button of the single button start transmitter supplied with
this optional kit. Enter the vehicle and turn the ignition key to the on but NOT
START position.
NOTE:
The system may have been configured to allow start by pressing
the transmitter start button once instead of twice. Please
consult your installation center as to the configuration of your
partictular system.
CAUTION!
Do not turn the key to the start position. This will cause the
starter motor to engage with the already running engine which
could result in damage. Step on the brake pedal to
disengage the remote start unit. The vehicle will continue to
run on its own power.
NOTE:
The engine will stop running before the expiration of the
pre-programmed run timer if you complete any of the following:
1.Pressing the lock, unlock, lock, button of your factory transmitter or the
optional Remote Start transmitter two times in succession while running
under control of the remote start.
Page 13
128-8970a
13 of 20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents