Table of Contents
Advertisement
WARNING:
Connecting the light blue/green to the high current switched output of trunk release
circuits, some remote start trigger inputs, will damage the control module.
Connect the light blue/green to terminal 86 of a 30 A automotive relay, connect terminal 85
to a + 12 volt source, and wire the remaining relay contacts to perform the selected
function of channel 5.
2 Pin White Connector: DASH MOUNTED LED.
Route the single blue wire in the 2 pin white connector from the receiver to the control module, and plug it
into the mating white connector on the side of the module.
2 Pin Blue Connector: PUSH BUTTON VALET SWITCH
Route the single gray wire in the two pin blue connector from the receiver to the control module and plug it
into the mating connector on the side of the module.
4 Pin White Connector: SHOCK SENSOR
Route the red, black, blue, and green wires in the 4 pin white connector from the shock sensor to the control
module, and plug one end into the shock sensor, and the other end into the mating white connector on the
side of the module.
Red, Green, & Red / Black 3 Pin White Connector: Door Lock Outputs PART # 1122906
The Red and Green wires will provide either a pulsed ground output to the factory door lock control relay, or
a pulsed + 12 volt output to the factory door lock control relay. In either case, the maximum current draw
through these outputs must not exceed 300 mA. The Red w/Black trace wire will provide a pulsed ground
only, and will only provide an output when the unlock button of the transmitter is pressed a second time after
a first unlock command was issued. This is used for second step unlock or all doors unlock in a two step
circuit. In this arrangement, Red, or Green is used to control the drivers door unlock relay, and the Red/
Black will be used to control unlock of all other doors.
3 Wire Ground Switched Single Step Door Locks
In this application, the red wire provides a ground pulse during arming, or the pulsed ground lock output.
Connect the red wire to the wire that provides a low current ground signal from the factory door lock switch
to the factory door unlock control relay.
The green wire provides a ground pulse during disarming, or the pulsed ground unlock output. Connect
the green wire to the wire that provides a low current ground signal from the factory door unlock switch to the
factory door unlock control relay.
Red/Black Not Used.
3 Wire Ground Switched 2 Step Door Locks
In this application, the red wire provides a ground pulse during arming or locking, connect the red wire to
the wire that provides a low current ground signal from the factory door lock switch to the factory door lock
control relay.
The green wire provides the first ground pulse during disarming or unlocking, connect this wire to the
drivers door unlock relay that requires a low current ground signal to unlock only the drivers door.
If the vehicle does not have a separate drivers door relay, one will have to be added. Locate the drivers door
unlock motor wire and cut it at a convenient location to allow wiring of an optional relay.
PART # 1122591
Page 8
128-8804b
8 of 16
Hide quick links:
Advertisement
Table of Contents
