Table of Contents
Advertisement
Quick Links
3 Button Remote Security System with
Stage Shock Sensor & Starter Disable
FEATURES :
2 Three Button Code Hopping RF Transmitters
Three Channel Code Learning Receiver (capable of accepting 4 transmitters)
Selectable Manual Override Mode
Remote Panic in all modes
Protected Valet
7 Function LED -(Light Emitting Diode) - Arm / Disarm / Zone1, 2, 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Instant Siren Activation
Low Current Horn Output
Starter Disable
True Last Door Arming (hardwire only)
Defective Zone By - Pass
Hardwire or Voltage Sense Selectable
Active or Passive Arming Selectable
Programmable Auto Lock On / Off
Programmable Auto Unlock, Drivers Door All Doors On / Off
Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
Programmable Active or Passive Door Locks
User Programmable Permanent Chirp Delete
On Command RF Chirp Delete from Transmitter (Software Selectable)
6 Tone Multi - Tone Siren
Additional Negative Trigger Input
RF Inhibit with ignition on
Parking Light Flasher
Plug In Dual Stage Shock Sensor
OPTIONS :
Remote Trunk Release
Remote Keyless Entry
Illuminated Entry
Multiple Vehicle Capable
Remote Starter
Remote Power Window Roll Up
Remote Garage Door Interface
Two Step Unlock Configurable
Model AX-200
Owner's Manual
128-6993
1 of 8
Advertisement
Table of Contents
Related Manuals for Audiovox AX-200
Summary of Contents for Audiovox AX-200
- Page 1 Plug In Dual Stage Shock Sensor OPTIONS : Remote Trunk Release Remote Keyless Entry Illuminated Entry Multiple Vehicle Capable Remote Starter Remote Power Window Roll Up Remote Garage Door Interface Two Step Unlock Configurable Model AX-200 Owner’s Manual 128-6993 1 of 8...
-
Page 2: Arming The System - Active
NOTE: Your system has the option of using a siren, the vehicle horn, or both for the sounding device. Where the siren is referenced below, the horn or both may in fact chirp, or beep. ARMING THE SYSTEM - ACTIVE 1. -
Page 3: Protection While The System Is Armed
PROTECTION WHILE THE SYSTEM IS ARMED Opening any protected door, hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone. -
Page 4: Intrusion Warning Signals
button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock. 1. As you approach the vehicle, press and hold the ARM / DISARM button on the keychain transmitter for 2 seconds. The dash mounted LED turns off. -
Page 5: Manually Overriding Your System
valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational. To use the valet mode, the system must first be disarmed either by using your keychain transmitter, or by operating the manual override sequence. -
Page 6: Eliminating The Normal Arm / Disarm Chirps
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. Custom Code Programming Example: To Change the code from the factory preassigned code of 11 to “52”... -
Page 7: Remote Panic Operation
1. Turn the ignition key on then off. 2. Within 10 seconds, press and release the valet push button switch three times. 3. If the chirps were on before you started, then you will hear 2 chirps indicating they have been turned off. - Page 8 Auto Unlock with ignition key Passive Arming No Lock in passive mode Hardwire doors, hood, and trunk Two Step Unlock RF Chirp Delete On © Audiovox Electronic Corp. 150 Marcus Blvd., Hauppauge, N.Y. 11788 AX-200 PASSIVE ARMING ARMED DISARMED VALET MODE...