Configuring Vlan Settings; Using The Ip Phones In A Vlan - Cisco SPA 501G Administration Manual

Configuring Security, Quality, and Network Features

Configuring VLAN Settings

STEP 5
Configuring VLAN Settings
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
Parameter
Syslog Server
Debug Server
Debug Level
NTP Enable
Primary NTP Server
Secondary NTP Server
Click Submit All Changes.

Using the IP Phones in a VLAN

If you use a VLAN your IP phone voice packets are tagged with the VLAN ID. (This
section is not applicable to the WIP310.)
If you are using a Cisco switch, Cisco discovery protocol (CDP) is enabled (this is
the default). CDP is negotiation-based and determines which VLAN the IP phone
resides in. CDP:
Description
Specify the syslog server name and port. This feature
specifies the server for logging system information and
critical events. If both Debug Server and Syslog Server
are specified, Syslog messages are also logged to the
Debug Server.
The debug server name and port. This feature
specifies the server for logging debug information. The
level of detailed output depends on the debug level
parameter setting.
The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
Enables Network Time Protocol (NTP).
Applies to the SPA 525G only.
IP address or name of primary NTP server. The phones
use these servers to synchronize its time. Defaults to
blank.
IP address or name of secondary NTP server. The
phones use these servers to synchronize its time.
Defaults to blank.
5
125