Configuring Vlan Settings; Using The Ip Phones In A Vlan - Cisco SPA 525G2 Administration Manual

Configuring Security, Quality, and Network Features

Configuring VLAN Settings

STEP 5
Configuring VLAN Settings
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide
Parameter
Debug Level
NTP Enable
Primary NTP Server
Secondary NTP Server
Enable Bonjour (SPA525G/
525G2 only)
Click Submit All Changes.

Using the IP Phones in a VLAN

If you use a VLAN your IP phone voice packets are tagged with the VLAN ID. (This
section is not applicable to the WIP310.)
If you are using a Cisco switch, Cisco discovery protocol (CDP) is enabled (this is
the default). CDP is negotiation-based and determines which VLAN the IP phone
resides in. CDP:
• Obtains the protocol addresses of neighboring devices and also discovers
the platform of those devices.
• Shows information about the interfaces your router uses.
Description
The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
Enables Network Time Protocol (NTP).
Applies to the SPA 525G only.
IP address or name of primary NTP server. The phones
use these servers to synchronize its time. Defaults to
blank.
IP address or name of secondary NTP server. The
phones use these servers to synchronize its time.
Defaults to blank.
Enable Bonjour networking that is used by Office
Manager and Cisco Configuration Assistant to discover
the Cisco IP phones. Choose yes to enable or no to
disable.
5
133