Ejecting The Cassette Tape Manually - Sony DIGITAL BETACAM DVW-707 Maintenance Manual

1-11. Ejecting the Cassette Tape Manually

1-11. Ejecting the Cassette Tape Manually
n
To avoid damage to internal circuit, be sure to turn off the
power, and then disconnect the power cord and/or battery
before following the steps below.
1. Open the ME cover of the outside panel in the direc-
tion of the arrow.
2. Press in the gear and turn it counterclockwise with a
Philips screwdriver while pressing the gear in.
n
Check that the tape is taken up the cassette reel while
turning the gear.
3. Turn the gear until the front lid opens, and then eject
the cassette tape.
Front lid
1-26
Outside
panel
ME cover
Gear
Turn while pressing
(counterclockwise)
m
. Never turn the gear no further after the front lid opened.
If the gear is turned moreover, gear phase will be out of
order, and the operation timing of the cleaning roller will
be shifted.
When adjusting the phase of the gear, refer to Section
"4-2-12. Timing Belt (Threading) Replacement" of the
Maintenance Manual Part 2 Vol.1.
. Closing the front lid
If the gear is turned moreover after the front lid opened,
the front lid cannot be closed and locked. To close the
front lid, turn on the power and close the lid.
If the front lid cannot be opened by turning the gear :
1. Remove the outside panel. (Refer to Section 1-6.)
2. Put the cassette compartment into the up position as
the cassette lid of the cassette tape opened.
(As for the moving up the cassette compartment, refer
to Section 1-8.)
3. Being careful not to damage the tape, eject the cassette
tape.
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P1