Sony DIGITAL BETACAM DVW-707 Maintenance Manual page 26

1-8. Removing/Reinstalling Cassette Compartment
Reinstalling
1. To create a clearance of 0.5 mm between the white
roller of joint arm and the end face of mechanical
deck, adjust the position of the joint arm.
Roller (white)
End face of mechanical deck
0.5 mm
Outside surface of roller
2. Slide the white lock-roller of cassette compartment in
an upward direction.
Lock-roller (white)
1-16
Joint arm
3. Slide the cam plate (A) on the right of the cassette
compartment all the way of the arrow until it stops.
4. Grasp the cassette compartment by the portion shown
in the figure and set it on the stage to insert the two
cassette-guide-pins onto the round hole of the stage.
Check that the other white-roller of joint arm posi-
tioned in step 1 is put in the notch of the cam plate (A)
on the right side.
5. Push down the lever of the cassette compartment and
check to see that the stage smoothly moves up and
down. If not moved smoothly, recheck the steps 1
through 4.
6. Fasten the cassette compartment using the three
screws.
n
Tightening Torque : 9 x 10
Screw
( M 1.4x2.5 )
Lever
Round
hole of
the stage
Cassette-
guide-pin
Notch
White-roller in step 1
Joint arm
Cam plate (A)
_2 N.m {0.9 kgf.cm}
Screws
( M 1.4x2.5 )
Stage
Notch of the
cam plate (A)
Cassette-guide-pin
Other white-roller
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P1