Icom IC-E80D Instruction Manual page 50

6
DV MODE PROGRAMMING
Access repeater setting (R1 USE)
The programmed repeater lists are assigned to use for the
access repeater (RPT1) or no in the DR mode. To use for
RPT1, repeater frequency, duplex direction and frequency
offset must be programmed.
!6 Push [ ](5) to enter the access repeater programming
state.
• Access repeater programming screen is displayed.
!7 Push [ ](2) or [ ](8) to select "YES" or "NO."
• When "NO" is selected, the repeater cannot be selected as the
access repeater (RPT1) in the DR mode.
• When "YES" is selected, the repeater can be selected as the
access repeater (RPT1) in the DR mode.
!8 Push [ ](5) to exit the state.
When "NO" is selected at step !7 , skip to step #1 .
When "YES" is selected at step !7 , push [ ](2) or [ ](8)
to select the access repeater (RPT1) programming.
Follow the next step !9 to program the repeater.
42
Frequency programming (FREQ)
This content appears when R1 USE is selected YES.
!9 Push [ ](5) to enter the frequency programming state.
• Frequency programming screen is displayed.
@0 Push [ ](2) or [ ](8) to select the frequency band.
• The selected number blinks at 1st digit.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• Push and hold [CLR](1) for 1 sec. to clear the displayed fre-
quency.
@1 Repeat step @0 until the repeater frequency is set.
@2 Push [ ](5) to set the frequency and exit the state.
@3 Push [ ](2) or [ ](8) to select the next content (duplex
direction programming).