Icom IC-E80D Instruction Manual page 17

t SKIP INDICATOR
" SKIP" appears when the selected memory channel is
set as a skip channel. (pgs. 108, 109)
" PSKIP" appears when the displayed frequency is set
as a skip frequency in memory mode. (pgs. 108, 109)
" PSKIP" appears during the frequency skip scan func-
tion is ON in the VFO mode. (p. 102)
y DR (D-STAR REPEATER) INDICATOR
(pgs. 19, 53, 54, 56)
Appears when the DR mode is selected.
u MEMORY INDICATOR (pgs. 18, 92)
Appears when memory mode is selected.
i MEMORY CHANNEL NUMBER INDICATOR
Shows the selected memory channel number.
(pgs. 18, 92)
"C0" or "C1" appears when the call channel is selected.
(pgs. 19, 93)
"TV" appears when the TV channel is selected.
(pgs. 19, 27)
o GPS INDICATOR
Appears while GPS function is in use.
• GPS indicator can be turned OFF in GPS.SET mode. (p. 137)
Stays ON when GPS receiver is connected and a valid
position data is received.
Blinks when an invalid position data is received.
!0 VOLUME INDICATOR (p. 20)
Appears when [DIAL] is assigned volume control, then
[ ]/[ ] are assigned tuning controls.
PANEL DESCRIPTION
!1 PRIORITY WATCH INDICATOR (pgs. 112–114)
Appears when priority watch is in use.
!2 S/RF METER
Shows the relative signal strength while receiving sig-
nals. (p. 24)
Shows the output power level while transmitting.
(pgs. 26, 27)
!3 POWER INDICATOR (p. 27)
" L" appears when low power is selected.
" SL" appears when S-low power is selected.
" M" appears when middle power is selected.
No indicator appears when high power is selected.
!4 ATTENUATOR INDICATOR (p. 25)
Appears when the RF attenuator is in use.
!5 OPERATING MODE INDICATOR (p. 25)
Shows the selected operating mode.
• DV, FM, FM-N, WFM and AM are available, depending on op-
erating band.
• "DVG" or "DV A" appears when GPS transmission or GPS-A
transmission is selected in the DV mode. (p. 138)
!6 FREQUENCY READOUT
Displays a variety of information, such as operating fre-
quency, set mode contents.
• The decimal point blinks during scan.
During memory mode operation, the programmed
memory or memory bank name is displayed.
2
2
9