Stp Bridge Settings - KTI Networks KFS-2621 User Manual

4.21 STP Bridge Settings

Configuration
STP Mode
Bridge Priority
Hello Time
Max Age
Forward Delay
[Apply]
Description
Disable – Disable STP or RSTP support
STP – Enable Spanning Tree Protocol (IEEE802.1D) support
RSTP – Enable Rapid Spanning Tree Protocol (IEEE 802.1w) support
The lower the bridge priority is the higher priority it has. Usually, the bridge with the
highest bridge priority is the root.
0 ~ 61440
Hello Time is used to determine the periodic time to send normal BPDU from
designated ports among bridges. It decides how long a bridge should send this
message to other bridge to tell I am alive.
1 ~ 10 seconds
When the switch is root bridge, the whole LAN uses this setting as the maximum age
time.
6 ~ 40 seconds
This figure is set at Root Bridge only.
Click to apply the configuration.
-53-