Finishing; Log Placement; Charcoal Embers; Vermiculite - Napoleon GVF42N Installation And Operation Instructions Manual

LOG PLACEMENT

PHAZER logs and glowing embers, exclusive to Napo-
TM
leon Fireplaces, provide a unique and realistic glowing ef-
fect that is different in every installation. Take the time to
carefully position the glowing embers for a maximum glow-
ing effect. Log colours may vary. During the initial use of the
fireplace, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
FIGURES 11a-e
A
1. Place the back log (#1) onto the base of the firebox.
Ensure that the back of the log rests against the rear log
support on the back wall of the firebox.
#2
B
2. Move the two small logs (#2 & #3) into position, lining
up the studs located on the burner with the holes on the
C
bottom of the logs.
3. Tear the glowing embers into pieces and place along
the front row of ports covering all of the burner area in front of
the small logs (#2 & #3). Care should be taken to shred the
embers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will
only glow when exposed to direct flame; however, care should
be taken to not block the burner ports. Blocked burner ports
can cause an incorrect flame pattern, carbon deposits and
delayed ignition. PHAZER
direct flame.

FINISHING

#1
#3
logs glow when exposed to
TM
#4
D
4. Place the bottom of the left crossover log (#4) against
the left tab protruding from the log support and between
the two far left grate posts. Place the top of log # 4 into the
pocket provided on the back log. Position the notch lo-
cated on the end of the center log (#5) against the middle
grate post with the other end of the log resting in the pocket
of the left (crossover) log.
E
5. Place the bottom of the right crossover log (#6) against
the right tab of the log support and the right outermost
grate post. Place the top into the pocket provided on the
center log (#5). Log #6 should also rest against the bracket
of the log support.

CHARCOAL EMBERS

Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine
dust found in the bottom of the bag should not be used.

VERMICULITE

Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to
be placed on the burner.

CHARCOAL LUMPS

Place the lumps between the logs in a realistic manner
taking care not to block any of the burner ports.
#5
#6
W415-0379 / B / 08.03.05
9