Blower Operation - Jøtul GF 300 BV Allagash Installation And Operation Instructions Manual

Figure 35. Attach Blower to
the stove bottom and connect
wires to Snapstat and female
control quick connect.

Blower Operation

The optional variable-speed blower will enhance heat
circulation around the firebox and out into the room. The
blower is controlled by a heat activated switch (snap-
stat) that will ONLY function when the control switch
is in AUTO setting. After the fire has been burning for a
time, the snapstat will react to the heat and activate the
blower. Fan speed may be manually adjusted with the
rheostat knob. If the burner turns off, the blower will be
shut off automatically when the stove cools down.
If automatic blower circulation is not desired, place
the blower control switch in the MANUAL position.
Speed
Control
Figure 36. Blower Controls
Snapstat
Connectors
M6 x 20 mm
Figure 37. Blower Wiring Diagram
Manual or
Automatic
Modes
LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVIC-
ING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER
AND DANGEROUS OPERATION.
VERIFY OPERATION AFTER SERVICING.
Au moment de l'entrentien des commandes, etiquietez
tous le fils avant le debranchement. es erreurs de ceblage
peuvent entra tun fonctionnement inadequat et dan-
Female
Hex Bolts
G
W
W
G
BL
BK
POWER
GY
SNAPSTAT
SUPPLY
P P
P
BL GY BR
AUTO OFF MANUAL
CAUTION:
ATTENTION:
137945_Rev_F 7.29.10
Male
Quickconnector
BLOWER
BK
BK BK
P
BK BK BK
P
RHEOSTAT
BR
P = QuickConnector Pin
SWITCH
21