Operation - Jøtul GF 300 BV Allagash Installation And Operation Instructions Manual

137945_Rev_F 7.29.10
WARNING:
AIR SHUTTER ADJUSTMENTS SHOULD ONLY BE
PERFORMED BY A QUALIFIED PROFESSIONAL
SERVICE TECHNICIAN.
Figure 29. Flame appearance on the "high" setting after
approximately 15 to 20 minutes burning.
CAUTION:
DO NOT ATTEMPT TO ALTER THE FLAME APPEARANCE
BY POSITIONING THE GAS VALVE CONTROL IN ANY
OTHER POSITION OTHER THAN THE FULL "ON"
POSITION.

Operation

Familiarize yourself with the controls of the GF 300 BV.
Make sure that anyone else using the appliance is also
familiar with the controls and operation procedures.
Always follow the Lighting Instructions on the inside back
cover of this manual and also located on the Rating Plate
attached to the burner assembly.
1. Once the pilot is lit, burner operation is controlled by
the rocker switch located at the left corner of the rear
shroud. See fig. 30.
ON / OFF - use for manual control of the burner.
T-STAT - use for optional thermostatic or remote con-
trol operation. The burner will be controlled by those
accessories.
2. During the first few fires, you may notice odor and/
or smoke from the stove. This is normal and results
from burn-off of manufacturing residue and curing of
materials. You may find it helpful to provide additional
ventilation and fresh air to alleviate this condition.
3. Condensation may occur on the glass upon each light-
ing of the appliance. This "fog" will disappear as the
appliance heats up.
4. Keep the controls and the area under the appliance
free of debris, vacuum this area frequently. Always keep
the appliance area clear and free from combustible ma-
terials, gasoline and other flammable liquids.
18
If a vacuum is used during any service on the stove,
ALWAYS be sure the stove is cold and there are NO hot
embers.
5. This appliance has a continuous burning pilot flame.
Exercise caution when using products having combus-
tible vapors. Always shut-off gas supply while servicing
the stove.
6. CAUTION: DO NOT OPERATE THIS APPLIANCE WITH THE
GLASS REMOVED CRACKED OR BROKEN.
Replacement of the glass should be done by a licensed
or qualified service person. Use only replacement glass
provided by your authorized Jøtul dealer. Never use
any substitute materials.
WARNING: OBSERVE CAUTION WITH THE GLASS. THE
GLASS PANEL MAY SHATTER UNEXPECTEDLY IF STRUCK
WITH AN OBJECT. ALWAYS HANDLE THE GLASS PANEL
WITH CARE. WHEN SERVICING THE STOVE ALWAYS
PULL THE GLASS ASSEMBLY STRAIGHT UP FOR REMOV-
AL.
7. Clean the glass only when necessary. Wipe surface
with a clean, damp soft cloth. Follow with a dry, soft
towel as desired. Take care not to scratch the glass
surface.
WARNING: DO NOT USE ABRASIVE CLEANERS ON THE
GLASS. NEVER CLEAN THE GLASS WHEN IT IS HOT.
BLOCKED FLUE SWITCH
NOTE: This appliance is equipped with a Spill Switch
which will disable the burner in the event that the
vent system becomes blocked. Located on the side of
the Draft Hood, at the back of the stove, the switch
has a reset button that, when pressed, will re-enable
burner function. See Fig. 27.
If the Spill Switch repeatedly shuts the burner off,
turn off the gas supply and call your dealer or service
technician. The Spill Switch will continue to shut off
the burner until the vent problem has been correct-
ed. Not all vent problems can be corrected as B-Vent
appliances are affected by atmospheric conditions
and house pressurization.
Figure 30. Burner Switch and Optional Blower Controls