Blower Operation - Jøtul GF 600 DV II Firelight Installation And Operation Instructions Manual

138090_Rev_F 7.29.10
Blower Motor
Housing
Ducts oriented to rear
Figure 35. Blower orientation.
4. Install the Blower: Orient the duct openings up
and to the back as in fig. 35. Route the snapstat
wire harness over the blower motor housing. Re-
move the wire ties from the controls wire harness
and route it under the blower to the side. Secure
the blower to the bracket with the wingscrew.
5. Attach either Snapstat wire connector to either
Snapstat terminal. See fig. 34
6. Install the Snapstat by sliding it all the way into
the slot in the bottom of the Snapstat Bracket as
shown in figs. 33 and 35.
7. Connect the male wire harness connector to the
female wire harness already installed in the stove.
See fig. 33.
8. Connect power cord to outlet only after all wire
connections have been made.

Blower Operation

The optional variable-speed blower will enhance
heat circulation around the firebox and out into the
room. Controls are located at the left side of the rear
shroud of the stove, fig.34. The blower is controlled
by a heat activated switch (snapstat) that will only
function when the control switch is in AUTO setting.
After the fire has been burning for a time, the snap-
stat will react to the heat and activate the blower.
Fan speed may be manually adjusted with the rheo-
stat knob. If the burner turns off, the blower will be
shut off automatically when the stove cools down.
If automatic blower circulation is not desired,
place the blower control switch in the MANUAL posi-
tion.
22
Snapstat Con-
nectors
Wingscrew
Choose Automatic or
Manual Modes
Figure 36. Blower Controls
G
W
G
BL
BK
POWER
GY
SUPPLY
P P
BL
GY
AUTO OFF MANUAL
Figure 37. Blower Wiring Diagram
Male QuickCon-
nector
Female QuickCon-
nector
Speed Control
BLOWER
W
BK
BK BK
P
BK
BK BK
P
RHEOSTAT
SNAPSTAT
BR
P
P = QuickConnector Pin
BR
SWITCH