Adjusting The Footboard Assembly - Invacare Wheelchair Pronto M61 Operating And Maintenance Manual

SECTION 8—FOOTBOARD ASSEMBLY
Installing
Make sure the detent balls of the quick-release pin are fully released beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
1. Position the footboard assembly onto the wheelchair frame so that the mounting hole
in the wheelchair frame aligns with the desired mounting hole in the footboard
assembly.
2. Install the quick release pin by depressing the button while sliding the pin in. Ensure
that the detent balls of the quick release pin are fully released beyond the outer edge
of the tube (Detail "A" of FIGURE 8.1).
Mounting Hole
Quick
Release Pin
FIGURE 8.1 Removing/Installing the Footboard Assembly

Adjusting the Footboard Assembly

Angle
NOTE: For this procedure, refer to FIGURE 8.2 on page 47.
1. Loosen the jam nut and set screw located underneath on the backside of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
Pronto® M51™and M61™with SureStep®
WARNING
Top Shroud
Pinch Point
Footboard
Assembly
Detent
Ball
46
DETAIL "A" - BOTTOM VIEW OF
FOOTBOARD
Quick Release Pin
Outer Edge
of Tube
Detent Balls
Part No 1125085