NOTE: This activity may be performed independently provided you have adequate mobility and
upper body strength.
NOTE: For this procedure, refer to
FIGURE 3.5.
1. Position the wheelchair as close as
possible along side the seat to which
you are transferring, with the rear
casters pointing away from it.
2. After the wheelchair is positioned
properly for transfer, verify that the
motor release levers are engaged. Refer
to Engaging/Disengaging Motor
Release Lever on page 57.
3. Flip back or remove arm on side of wheelchair you are transferring from.
4. Shift body weight into seat with transfer.
During independent transfer, little or no seat platform will be beneath you. Use a transfer
board if at all possible.
Reaching, Leaning and
NOTE: For this procedure, refer to FIGURE 3.6.
Position the front and rear casters so that they are extended as far forward as possible and
engage motor release levers.
DO NOT attempt to reach objects if you have to move forward in the seat or pick
them up from the floor by reaching down between your knees.
FIGURE 3.6 Reaching, Leaning and Bending - Forward
Part No 1125085
SECTION 3—SAFETY/HANDLING OF WHEELCHAIRS
Minimum Gap Distance
FIGURE 3.5 Transferring To and From
Bending - Forward
WARNING
21
Pronto® M51™and M61™with SureStep®
Other Seats