Depth - Invacare Wheelchair Pronto M91 Base Owner's Manual

Depth

NOTE: For this procedure, refer to FIGURE 7.3.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
Make sure the detent balls of the quick release pin are fully released and protruding
past the outer edge of the tube before operating the wheelchair. Otherwise, injury
and/or damage may result.
Keep detent balls clean.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls of the quick release pin are
fully released and past the outer edge of the tube (Detail "A").
Mounting
Hole
Three
Depth
Adjustment
Holes
Quick
Detent
Release
Ball
Pin
FIGURE 7.3 Adjusting the Footboard Assembly - Depth
Part No 1143153
WARNING
Wheelchair Frame
Footboard
Assembly
51
SECTION 7—FOOTBOARD ASSEMBLY
DETAIL "A" - BOTTOM
VIEW OF FOOTBOARD
Quick Release Pin
Outer Edge
of Tube
Pronto® M91™Base with SureStep®
Detent Balls