Spj+, Mk6I Spj+ W/Pss And Mk6I Spj+ W/Acc Joystick Switches And Indicators; On/Off Button; Speedometer - Invacare Wheelchair Pronto M91 Base Owner's Manual

SECTION 5—WHEELCHAIR OPERATION
SPJ+, MK6i SPJ+ w/PSS and MK6i SPJ+ w/ACC Joystick
Switches and Indicators
NOTE: For the following information, refer to FIGURE 5.3.
On/Off
Button
Decrease
Speed Button
(Tortoise)
GREEN
LED
*NOTE: The mode button is only
present on SPJ+ w/ACC joystick.
FIGURE 5.3 SPJ+, MK6i SPJ+ w/PSS and MK6i SPJ+ w/ACC Joystick Switches and Indicators

On/Off Button

This button is located at the front of the joystick housing. It is used to turn the wheelchair
On and Off, to remove the joystick from sleep mode (if programmed) and to lock or
unlock the joystick (if programmed).

Speedometer

The speedometer is used to show the maximum speed. The right‐most LED indicates
current maximum speed setting. The bottom left GREEN LED flashes to indicate that the
joystick is in speed limit mode. Speed limit mode limits the drive speed to a pre‐
programmed value, typically when the seat has been elevated and the wheelchair is
required to drive at 20% speed.
Pronto® M91™Base with SureStep®
Information
Gauge
Display
Mode Button*
Service Indicator
34
Speedometer
Increase
Speed Button
(Hare)
DETAIL "A" -
FRONT VIEW
Charger/
Programming
Input
Joystick
Additional
Input for
Powered
Seating
Switch
Not Active
Part No 1143153