Mpj+ Joystick Switches And Indicators; Drive Select Toggle Switch; Speed Control - Invacare Wheelchair Pronto M91 Base Owner's Manual

MPJ+ Joystick Switches and Indicators

NOTE: For this procedure, refer to FIGURE 5.4.

Drive Select Toggle Switch

The drive select toggle switch is located on the left side, below the LCD. The drive select
position is momentary, meaning that it will return to the neutral position after a selection
is made.
This switch allows the operator to select the type of operation or performance which best
suits a particular control need or situation. The DRIVE 1 program uses performance
values which are independent of those used for the DRIVE 2 or 3 or 4 program. As an
example, an operator may have a control need for spasticity in the morning and a very
different need in the afternoon. DRIVE 1 can be programmed for higher speeds and
quicker response while DRIVE 2 can be programmed for slower speeds and less
responsiveness or vise versa. The other two drive programs could be indoor and outdoor
versions of DRIVE 1 and DRIVE 2.
Selecting the Drive Mode
1. Move the toggle up and release. DRIVE 1 (
2. Move the toggle up and release again. DRIVE 2 (
3. Move the toggle up and release again. DRIVE 3 (
4. Move the toggle up and release again. DRIVE 4 (
5. Move the toggle up and release one more time to select DRIVE 1 (
Charger/Programming Input
(Front of Joystick)
Drive Select Toggle Switch
Programmable
Mono Port 1/2 or
External Mode
Switch
FIGURE 5.4 MPJ+ Joystick Switches and Indicators

Speed Control

The speed control knob is located on the side of the joystick housing.
1. Rotate the knob clockwise (forward) to increase the speed of the wheelchair to the
programmed max speed.
Part No 1143153
Memory Card Slot
Joystick
37
SECTION 5—WHEELCHAIR OPERATION
) will appear on LCD.
) will appear on LCD.
) will appear on LCD.
) will appear on LCD.
LCD Display
Mode Switch
Speed Control Knob
Remote
On/Off
Input
To Controller
Pronto® M91™Base with SureStep®
).