Section 7-Footboard Assembly; Removing/Installing The Footboard Assembly; Removing; Installing - Invacare Wheelchair Pronto M91 Base Owner's Manual

SECTION 7—FOOTBOARD
ASSEMBLY
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Pinch point may occur when rotating the footboard assembly.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
LIMITED CLEARANCE BETWEEN FOOTBOARD AND CASTER - The user's feet
MUST remain on the footboard while operating the wheelchair. If the user's feet
are allowed to rest off the side of the footboard they may come in contact with the
caster possibly resulting in injury.

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 7.1 on page 50.

Removing

1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.

Installing

Make sure the detent balls of the quick release pin are fully released and protruding
past the outer edge of the tube before operating the wheelchair. Otherwise, injury
and/or damage may result.
Keep detent balls clean.
1. Position the footboard assembly onto the wheelchair frame so that the mounting hole
in the wheelchair frame aligns with the desired mounting hole in the footboard
assembly.
2. Install the quick release pin by depressing the button while sliding the pin in. Ensure
that the detent balls of the quick release pin are fully released and protruding past the
outer edge of the tube (Detail "A").
Part No 1143153
SECTION 7—FOOTBOARD ASSEMBLY
WARNING
WARNING
49
Pronto® M91™Base with SureStep®