Section 6-Front Riggings; Installing/Removing/Using The Footrest/Legrest; Installing - Invacare P9000 XDT Operating & Maintenance Manual

SECTION 6—FRONT RIGGINGS
SECTION 6—FRONT RIGGINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF
switch on the joystick is in the OFF position.

Installing/Removing/Using the Footrest/Legrest

NOTE: For this procedure, refer to FIGURE 6.1.
NOTE: This procedure applies to the swingaway footrest and elevating legrest.

Installing

1. Turn the swingaway footrest assembly to the side (open footplate is perpendicular to
wheelchair).
2. Install the hinge plates on the swingaway footrest assembly onto the hinge pins on the
wheelchair frame.
3. Push the swingaway footrest assembly towards the inside of the wheelchair until it
locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat this procedure for the other footrest assembly.
FIGURE 6.1 Installing/Removing/Using the Footrest/Legrest
™
P9000 XDT
WARNING
Hinge
Pins
Footrest
Release Lever
Swingaway
Footrest
Assembly
Footplate
Hinge
Plates
34
Part No. 1118386