Section 4-Front Riggings; Installing/Removing Front Riggings; Installing; Removing - Invacare Lightweight Operation And Maintenance Manual

SECTION 4—FRONT RIGGINGS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings

NOTE: For this procedure, refer to FIGURE 4.1.

Installing

1. Turn the front rigging assembly to the
side (open front rigging is
perpendicular to wheelchair).
2. Install the hinge plates on the front
rigging assembly onto the hinge pins
on the wheelchair frame.
3. Push the front rigging assembly
towards the inside of the wheelchair
until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat this procedure for the other
front rigging assembly.
5. To release the front rigging, push the
front rigging release lever inward,
rotate front rigging outward.

Removing

1. Push the front rigging release lever inward
2. Rotate swingaway front rigging assembly outward.
3. Lift the swingaway front rigging assembly off the hinge pins.
Part No. 1114811
SECTION 4—FRONT RIGGINGS
WARNING
Hinge
Pins
NOTE: Swingaway footrest shown.
FIGURE 4.1 Installing/Removing Front
31
Lightweight, Standard and Heavy Duty Wheelchairs
Front Rigging
Release Lever
Front Rigging
Assembly
Footplate
Hinge
Plates
Riggings