Label Location - Invacare Lightweight Operation And Maintenance Manual

IMPORTANT NOTICE
The wheel locks on this wheelchair have been
pre-set at the factory to comply with the
Veterans Administration functional Standard
8320.01 of the Federal Register, paragraph
3.2.4.5.3. If these wheel locks do not meet
your needs, follow instructions below.
!
Any wheel lock adjustments should embed
wheel lock shoe at least 1/8" into tire when
locked (3/16" on pneumatic tires).
INSTRUCTIONS FOR WHEEL
LOCK ADJUSTMENTS
1. Loosen wheel lock mounting fastener,
which runs through mounting bracket and
frame.
2. Slide clamp toward rear wheel until wheel
lock shoe is embedded into tire material at
least 1/8" when handle is engaged to the
lock position (3/16" for pneumatic tires).
3. Tighten mounting fastener to secure
mounting bracket in desired location and
recheck lock shoe embedding.
4. Inspect for correct locking action BEFORE
actual use.
Part No. 1114811

LABEL LOCATION

Wheelchairs Only
NOTE: On all adjustable
anti-tippers
00078X021-0394
Standard and
Lightweight
WARNING
Refer to Owner's Manual
for proper anti-tipper
setting.
1085379
REV. 5/98
11
Lightweight, Standard and Heavy Duty Wheelchairs
LABEL LOCATION
Crossmember
Lower Frame
Tube
Heavy Duty
Wheelchairs Only
WARNING
DO NOT OPERATE WITHOUT
THE ANTI-TIP TUBES
INSTALLED.
P/N 60106X144