Logging Into The System Controller; To Log Into The System Controller Using The Serial Management Port - Fujitsu Sparc Enterprise T2000 Installation Manual

You can now use the SP network management port at any time to access the system
controller. See
Port" on page

Logging Into the System Controller

If you are powering on the system for the first time after installation, use the system
controller serial port to power on the system and run POST. See
System Controller Using the Serial Management Port" on page
If the network management port has already been configured, you can use it instead
of the serial management port. See
Network Management Port" on page
To Log Into the System Controller Using the
▼
Serial Management Port
After the system controller boots you can access the ALOM CMT command line
interface to configure and manage the system.
The sc prompt is displayed at the first time the system controller is booted. The
default configuration provides an ALOM CMT user account called admin. There is
no default password, so you must create a password using the system controller (sc)
password command.
1. If this is the first time the system has been powered on, use the password
command to set the admin password.
.........................
TTYD - - PASSED
TTYC - - PASSED
MEMORY - - PASSED
MPC885 - - PASSED
sc> password
password: Changing password for admin
Setting password for admin.
New password: new_password
Re-enter new password: new-password
sc>
38 SPARC Enterprise T2000 Server Installation Guide • April 2007
"To Log Into the System Controller Using the Network Management
43.
"To Log Into the System Controller Using the
43.
"To Log Into the
38.